AVM OVATION MP 6.2, Руководство по эксплуатации

Страница: 7 / 32

7
16
Analogue output left (XLR)
17 Analogue output right (XLR)
18 Analogue output right (Cinch/RCA)
19 Analogue output left (Cinch/RCA)
20 Digital output optical
21 Digital output coaxial
22 USB B digital input
23 Digital input optical 2
24 Digital input optical 1
25 Digital input coaxial 2
26 Digital input coaxial 1
27 Digital input AES/EBU
28 WiFi antenna socket
29 USB digital input for storage media
30 Reset button
31 Network port (LAN)
32 Status LED
33 Update button (Streaming module)
34 Mains connector
35 Mains switch
36 Trigger outputs
37 Connector for external IR receiver
38 Phase LED
39 Link
40 Configuration port (updates)
1.3 Installation and cooling
The unit can become hot depending on demanded output power or environmental
temperature. Therefore it is important, that the cooling air can flow unhindered into the air
inlet in the bottom and flow out through the holes in the rear panel. Direct exposure to
sunlight is not recommended because this will heat up the unit and may cause unwanted
malfuctions.
1.4 Connection to mains
Connect the unit to the mains outlet (34) by using the power cord which is (in some countries)
delivered together with the unit. Make sure that mains voltage is according to the value
printed on the rear panel of the amp (near mains connector).
CAUTION:
Keep the unit switched off (35) until all audio connections are made.