Avital AVISTART 6501, Руководство по установке

Страница: 14 / 28

Glow Plug Light Input
The AviStart can start a diesel engine by one of two methods.
Pre-ignition
The module can be programmed to turn the ignition "ON" for 15 seconds
before the starter engages. This will allow the glow plugs time to warm up and
the glow plug light to turn off.
Glow Plug Light Monitoring
The glow plug light (+) input wire will monitor the glow plug light in the
dashboard. When a remote start is attempted, the ignition will turn on and
when the glow plug light turns "OFF" the engine will start
1 . Locate the glow plug light wire that will show (+) 12 volts while the
ignition key is on and the glow plug light wire is illuminated.
2 . Connect the AviStart ORANGE/BLACK wire to the vehicle glow plug
might wire.
NOTE: Do not use both "pre-ignition" and "glow plug light monitoring" at
the same time (use one or the other).
Trunk Switch
1 . Locate the vehicle trunk switch that shows ground when the trunk is open
only.
2 . Connect the alarm module TAN/BLACK wire to the vehicle trunk switch
wire.
3. If the vehicle does not have a trunk switch, install a pin switch and
connect it to the alarm module TAN/BLACK wire.
Ignition Switch Connections
NOTE: Because these wires can draw high current, we recommend that they
be soldered and shrink tubed or taped. If only one PINK wire is needed, tape
the end of the second PINK wire to prevent a short circuit. The main control
module has an 18 ga PINK wire that must be connected to the vehicle
ignition wire with one of the satellite module 14 ga wires.
12
AviStart 6501 Installation Manual