12
ADDITIONAL INFORMATION FOR PROGRAMMING THE DCP
SMS COMMANDS
+
All DCP parameters can be remotely configured via SMS sent to the SIM card’s number.
+
Each SMS message should begin with ‘Pin1234’ which is the access code to read or make any changes to the
configuration of the DCP.
+
You can modify or check several parameters in each SMS by separating them with commas ","
To send parameter information:
Text
Description
Pin1234,Pzzz xxx
(send)
•
Pin1234 is default PIN code for DCP
•
Pzzz is the programming command
•
xxx is the parameter
To read parameter information:
Text
Description
PinXXXX,Pzzz?
(send)
•
Pin1234 is default PIN code for DCP
•
Pzzz is the programming command
•
“?” is to request a parameter read
Note: Use a question mark ‘?’ when you are reading parameters.
Examples:
1.
To program telephone number 1 in the DCP when connected to a DAU
E.g: Pin1234, P031 0123456789 (send, text message will come back with P031=0123456789)
2.
To retrieve telephone number 1 in the DCP when connected to a DAU
E.g: Pin1234, P031? (send, text message will come back with P031= or with the programmed number)
CMD
Description
Default value
P005
CCID- Unique Identifier of the Sim Card
Country dependent
P020
DCP Background Call Mode
P020=00 -> Transparent Protocol
P020=06 -> CAN Protocol
P020=21 -> P100 Protocol
21 (Autodialler’s need to make
Background calls in P100 Protocol)
P064
Background Call Periodicity (in Minutes)
4320 (3 days)
P030
Maintenance Alarm Number
(Blank)
P031
Alarm Number 1
(Blank – Insert your alarm number here)
P032
Alarm Number 2
(Blank)
P033
Alarm Number 3
(Blank)
P034
Alarm Number 4
(Blank)
P035
Background Number (not used with DAU)
3308084431 (must match Background
Number in Autodialler, without prefixes)
P008
Enable Guidance Message
0 (disabled)
1 (enabled)
P085
Language
1 – Spanish, 2 – Portuguese, 3 – Italian, 4
– English, 5 – German, 6 – French
P091
Super settings set up
0000
P003
DCP information (software version, type of DCP)
See example on next page
Note: The DCP’s default settings are set to 000.