33
current page and return to the user login interface.
4.2.9 Wireless Network
If user's equipment has a wireless network module, then "Network Configuration" page will have "Wireless
Network" configuration option. Specific configuration is shown as below:
1)
Network Settings
Wireless network
configuration:
Network Interface Enable:
check to set the following items.
DHCP:
obtain IP automatically if checked.
IP Address:
set wireless WIFI IP (default: 192.168.1.250). If DHCP is checked, IP should be assigned
automatically).
Note:
wireless IP address cannot be in the same segment with wired IP address.
Subnet Mask:
set the wireless IP subnet mask (default255.255.255.0).
Default Gateway:
set the wireless IP default gateway (default 192.168.1.1).
SSID:
user can modify on their own (default: test).
Encryption:
password can be set if checked.
Password:
password can be changed if checked.
Click "
Save
". Settings will take effect after the message "saved successfully" shows.
Note:
SSID and password should be filled correctly, otherwise the wireless WiFi connection will not be available
after restart.
2)
WiFi Hot Link
Click “
search
” to search for the WIFI hotspot.
Double-click the dialog box after searching WIFI hotspot, then input the WIFI password. It is connected
successfully after “successful connect” window shows.
3)
Wireless WiFi Login Page
If DHCP is not checked on the configuration page (automatically obtain IP), then open the browser, enter the
wireless network IP address in the address bar (default 192.168.1.250), press
Enter
to login to the construction
page; If DHCP is checked, then IP will be obtained automatically. Log in to the specific router or switch’s user
interface settings to view the allocation of IP address.
5.
Serial Communication Control
Under common working conditions, the camera could be controlled through RS232 interface (VISCA). RS232C
serial parameters are as below:
Baud rate: 2400/4800/9600/115200 bits/sec; Start bit: 1; Data bits: 8; Stop bit: 1; Parity: None.
After powering on, camera first goes to the left, then back to the center position. Initial configuration is complete
after the zoom moves to the farthest and then back to the nearest position. If the camera’s preset 0 position exists, it
will be at 0 preset position after initialization. At this point, user can control the camera by the serial commands.
Содержание AV-1362U
Страница 7: ...3 2 Upside down installation steps...
