Aviosys 9255W, Руководство пользователя

Страница: 11 / 77

- 11 -
Setting up your device
Before we Start
*Before setting up the device make sure of the following:
1.)
All the package contents are all included if anything is missing please contact the dealer
where the device was purchased from.
2.) Check the power input cable is working correctly.
3.) Check all cables to make sure there are no problems with it.
Hardware Connection
Please refer following procedure :
1.) Connect the Ethernet cable (RJ45) to the 9255W to your local area network.
2.) Then connect the power cable into the power input port of the 9255W .
3.) Connect the device that you would like to control to the output plug on the top of the 9255W .
4.) Switching the power source to ON status , this switch is located at the rear of 9258.
5.) After power on for around 45 seconds , there is a short beep sound for 9255W which
means the system reboot successfully
6. ) Go to page #14 for software installation guide
– use IPEDIT.exe to log in the webpage of
9255W .
Software Installation
The
Media Link - IP Family CD comes with the device , it will have all the necessary software to
run and setup the device.
IP Power Software:
IP Edit (Required)
IP Power Center *(
For multiple IP Power devices control )
Installing Software
1.) Place the Media Link-IP Family CD into the CD/DVD Rom drive.
(The CD should auto run but if it does not go to the CD/DVD Rom drive and select the
“
autorun.html
” file.)