E-6
Safety Precautions
• Do not do the followings
• Do not put anything heavy on the projector.
• Do not step on the projector, rack, or stand. Do not hold or hang on the projector.
Doing so could cause the projector to roll over or break, resulting in injury.
Especially be careful if small children are near.
• Do not use the rack unless the casters are locked when placing the projector on a rack with casters.
Doing so may cause the projector to move or roll over, resulting in injury.
• Do not turn the lamp on/off within one minute after it is turned off/on. Extremely high voltage is generated in the lamp just
after it is turned on. Turning the lamp on/off too frequently could cause the lamp to deteriorate or break, resulting in mal-
functions of the projector.
• Do not project an image with the lens cap attached.
• Do not use with the air filter removed. Doing so could cause damage or malfunction.
• Do not lift the projector by grasping the focus adjustment ring. Doing so will cause a fault or damage.
• After disconnecting the power cable from the projector, allow an interval of at least 5 seconds before inserting it again.
• Moving the projector
The unit is meant to be used in a stationary position.
• Be sure careful of the glass surface at moving the projector while holding the handles.
• If the document cover is not inserted enough, it may get loose and fall off while you carry it.
• Avoid swinging it around or treating it roughly.
• Care of the power cable and plug
• Do not put the power cable near a heater.
Doing so could cause the sheath of the cable to melt down, resulting in fire or electric shock.
• Do not connect or disconnect the power cable with wet hands. Doing so could cause electric shock.
• Be sure to establish a ground connection. The ground connection must be made before plugging the power cable into the
outlet.
Connect or insert the ground wire to a ground terminal only; do not connect it elsewhere.
• Be sure to pull out the power cable and disconnect any cable connections between units and release the anti-theft lock
before moving the projector.
Moving the projector with cables connected may cause fire or electric shock if the cables are damaged.
• DO NOT REMOVE ANY SCREWS except the lamp cover screw and two lamp unit screws. Otherwise you could receive
an electric shock.
• About the projection lamp and other optical parts
Optical parts such as the light source lamp, fan, and color wheel are parts that require periodic replacement (i.e., periodic
replacement parts).
When the projector is used continuously for long periods (of 5 or more hours daily), the replacement of those parts may
even become necessary in less than one year of use.
Note also that use of the projector in places where there is tobacco smoke or a lot of dust may shorten the replacement
cycle of the periodic replacement parts. Please inquire with the dealer for details.
• Keep your face away from the exhaust vents.
• If the lamp is broken, dust may enter your eyes or mouth. Be sure to keep your face away from the exhaust vents.
Otherwise, it may result injury.
(If foreign matters enter the eyes, consult an ophthalmologist.)
