11. Replace the locking ring to secure the conduit pipe.
Mounting the Dome Camera to an Electrical Box
Perform the following steps if the required electrical components and cables will be contained in an electrical
gang box inside the mounting surface.
1. If a flush mount is preferred, remove the wall plate gasket.
2. Mount the wall plate to the electrical box. Use the hole configuration that matches the box:
A — UK standard single gang box
B — Octagon gang box
C — 4” gang box
E — US standard single gang box
NOTE:
It is recommended that silicone sealant be applied around the edges of the wall plate gasket to
prevent moisture from entering the mounting surface or electrical box.
3. Pull the required cables through the cable entry hole on the wall plate.
4. Insert the sealing grommet with the required cables pulled through into the cable entry hole on the
bottom of the camera. For more information on using the sealing grommet, see
Inserting Cables through
the Sealing Grommet
on page 8
5. Mount the camera to the wall plate using the wall plate mounting screws.
14
Mounting the Dome Camera to an Electrical Box
