1. Remove the sealing grommet from the camera.
2. Pull the tab on the grommet to open a hole for the Ethernet cable.
3. Push an Ethernet cable through the grommet by one of the following methods:
a. If the Ethernet cable is uncrimped, push the cable through the grommet.
b. If the Ethernet cable is already crimped, place the grommet piercing cap on the Ethernet
connector then push the cable through the grommet.
Ensure that the orientation of the cable and grommet matches the one shown in the image.
4. Push any other required cables through the grommet.
NOTE:
If you will pull multiple cables through the sealing grommet, apply silicone sealant to seal any gaps
in the grommet.
Mounting the Dome Camera
Mounting the Dome Camera Using the Bottom Cable Entry Hole
Perform the following steps if the required cables will be coming out of the mounting surface. Use this
procedure on surfaces that can easily be cut, such as aluminum, and when the cables should be kept out of
sight.
1. Use the mounting template to drill 3 mounting holes and one cable entry hole into the mounting surface.
2. Pull the cables through the cable entry hole in the mounting surface.
3. If a flush mount with the surface is preferred, remove the wall plate gasket.
4. Drive 3 screws to fasten the wall plate to the ceiling or wall.
NOTE:
It is recommended that silicone sealant be applied around the edges of the wall plate gasket to
prevent moisture from entering the mounting surface.
5. Insert the sealing grommet with the required cables pulled through into the cable entry hole on the
bottom of the camera. For more information, see
Inserting Cables through the Sealing Grommet
on the
previous page.
6. Mount the camera body to the wall plate with the wall plate mounting screws.
Mounting the Dome Camera
9
