6. Mount the ACM Embedded Controller and the Address 0 V100 as shown below (the arrows show screws).
ACM
Embedded
Controller
V100
Address 0
7. Mount the other V100 subpanels on the pre-installed studs mounted on the door as shown below (the
arrows in the picture below show Hex nuts that will connect to the studs).
V100
Address 3
V100
Address 2
V100
Address 1
8. Using a small slotted screwdriver gently turn the V100 addresses as follows:
l
Ensure the V100 mounted below the ACM Embedded Controller is at Address 0.
l
Set the other V100's mounted on the door as per the picture below.
V100
Address 1
V100
Address 2
V100
Address 3
NOTE:
Always use stranded wires - the recommended gauges are:
l
18 AWG – low voltage power wires.
l
22 AWG – data wires.
16
Install the ACM Embedded Controller and V100 Subpanels
