Install the ACM Embedded Controller and V100
Subpanels
Shown below is an overview of the positioning of the ACM Embedded Controller and V100 subpanels.
V100
V100
V100
ACM
Embedded
Controller
V100
FPO150
C8
B100
D8P
Install the ACM Embedded Controller and V100 subpanels as shown below:
1. Unbox the Avigilon ACM Embedded Controller and V100 subpanels.
2. Locate 8 screws and 12 Hex nuts from the accessory bag in the FlexPower box.
3. Verify battery jumper (Batt) on the ACM Embedded Controller has been set to ON position.
CAUTION —
This is a non-PoE device. Do not connect J1 (Ethernet port) to a PoE-capable port. This
applies to both direct PoE Power Sourcing Equipment (Endspan PSE) and PoE injector (Midspan PoE)
equipment. Not all PSE's correctly detect non-PoE capable devices, and such PSE's may not function as
expected when connected to non-PoE equipment.
4. Set Port 1 terminating jumper (P6 Port 1 TERM Resistor) to IN position.
5. Verify Port 2, 3, 4 terminating jumpers are in the OUT position.
Install the ACM Embedded Controller and V100 Subpanels
15
