Avidyne 700-00004 Series, Руководство по установке, Страница: 56 / 132

EX5000 Installation Manual
P/N 600-00073 Rev 24
- 46 -
5.7 Traffic Sensor Setup
The aircraft should be equipped with one of the following Traffic Sensors. Follow the setup instructions
for the appropriate sensor:
● For TAS, see Section 5.7.1, “TAS (SkyWatch & Bendix/King) Setup” on page 47.
● For TCAD, see Section 5.7.4, “TCAD Setup” on page 49.
● For TIS, Section 5.7.7, “TIS Setup” on page 51.
Note:
If you need to switch between types of installed traffic sensors, first change the traffic sensor
type to
None , press Save , and restart the EX5000. Then select the new traffic sensor type.
Table 20 describes the system configuration options (option availability depends on the EX5000
configuration ordered):
!
The EX5000 only supports the listed Traffic sensors. If a traffic sensor not on the
supported list is connected to the MFD some of the data may display but its accuracy
and traffic sensor control functions may be incorrect or inoperable. Display of traffic
sensor data is not a guaranty of correct traffic sensor installation and configuration.
Table 20: Traffic Setup Configuration Options
System Option Values Notes
TAS External Controller? Check/Clear Check this box if a dedicated external Skywatch
controller is installed. With this box checked the
EX5000 does not initiate Skywatch standby or Self
Test functions.
TCAD
(9900B
selected) Shields Terminal
Standard
Enroute
Range Terminal 0.5 – 1.5 nm
Standard 1 – 3 nm
Enroute 2 – 15 nm Limited to 6 nm max. by the 9900B sensor
Height Terminal 200 – 1000 ft.
Standard 500 – 1500 ft.
Enroute 1000 – 2000 ft.
TIS-G None
TCAD TYPE 9900B
9900BX