Avidyne 700-00004 Series, Руководство по установке, Страница: 57 / 132

EX5000 Installation Manual
P/N 600-00073 Rev 24
- 47 -
5.7.1 TAS (SkyWatch & Bendix/King) Setup
SkyWatch uses an ARINC 429 data connection between the TRC (Transmitter/Receiver Computer)
and the MFD.
➤
To set up the TAS Traffic Sensor:
1. From the Maintenance Mode Page, select Traffic Setup. The Traffic Setup Page displays:
Figure 13: TAS selection on Traffic Setup Page
2. Set the following options:
■ Sensor— TAS
■ Port —Select the MFD ARINC 429 port to which the TAS sensor is wired.
■ TAS Type —Skywatch or Bendix/King.
Note:
Check the wiring considerations discussed in Section 4.7.7, “Traffic Sensor Wiring” on
page 26.
■
External Controller? (SkyWatch only)—If this box is checked, control of Standby/Operate
and Self Test functions is not performed by the MFD but by the SkyWatch display or a GPS.
Only one device may control the Standby/Operate and the Self Test functions; therefore they
are not available on the MFD when the External Controller box is selected.
3. When you are done, press Save . Press Cancel to exit without saving changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press
Restart System . If needed, see Table 22, “Traffic Messages,” on page 52.