UNIVERSAL CONNECTED CONTACTOR
EN
7
C - INSTALLATION
Before the device is permanently installed, make sure it is within WiFi range of your router. If it is installed
outside WiFi range, you should install a WiFi repeater to boost the signal.
This product should not be installed outdoors. Position it in the housing of the gate motor drive or in a
waterproof junction box.
1 - INSTALLATION ON SLIDING GATE
Put the gate in closed position
Attach the passive magnet to the gate. Install the magnet bracket on the ground, leaving a gap of no more
than 13mm between the magnets. The magnets must not touch.
2 - INSTALLATION ON SWING GATE
Passive magnet
Grommet
.
Electronic
card
Contactor
Waterproof
housing
Pre-wired
magnet
Install the pre-wired magnet on the panel on the side of the electronic card. Install the passive magnet on the
other panel, leaving a gap of no more than 13mm. The magnets must not touch.
3 - GARAGE INSTALLATION
