UNIVERSAL CONNECTED CONTACTOR
EN
12
F - USING THE PRODUCT
1 - USE VIA THE APPLICATION
Warning:
Thanks to the position of the magnets,
the contactor can indicate whether or not your gate
is closed. When the app indicates that the gate is
open, it means that the two magnets are no longer
in contact with each other. This does not however
guarantee that the gate is actually completely
open. In the event of faulty operation (e.g.: obstacle
detection, motor error, etc.), if the gate remains ajar
the contactor cannot be held responsible.
IMPORTANT:
The dry contact signal is the same
whether the opening or closing of the gate is
triggered. The contactor will take into account the
last command given as well as the position of the
magnets to determine the current command to be
displayed in the app.
However, control logics are specific to each
manufacturer and subject to different settings.
Therefore the contactor does not know exactly the
operating status of the gate motor drive when it is
moving, or what the control logic will require the
motor drive to do when a new command is given.
As a result, it is possible that the gate may move in
the opposite direction to what the app is indicating.
(e.g.: automatic closing activated, motor drive
behaviour after a switch to safety mode, “stop”
command while in motion, control by a third party
device, etc.). In any event, wait until the end of the
app’s display to determine the status of the gate
(closed or not closed).
1
2
4
3
6
5
1
Gate position status (display when in
operation) in relation to the magnets
2
Alert setting and operating time prior to alert
3
Countdown to contact trigger
4
Command trigger button
5
History of opening/closing requests
6
Time programming of contact triggers
Press the command trigger button in the app. The
contactor will send the command order to the
motor drive. The opening or closing display will start
within the given deadline. If your motor drive fails to
complete its cycle within the determined operating
time, go to the
Alarm
setting (2), then
close
reminder.
Adjust the cycle time of your automatic
gate.
When the determined operating time is exceeded, if
the magnets did not separate during opening, or if
the magnets did not come together during closing,
the app displays this message.
2 - USING THE PRODUCT WITH GOOGLE
HOME
Note:
the name you give your Avidsen Home
devices is the one that will be recognised by Google
Assistant.
Example: if you have a contactor named “gate”, “OK
Google, open gate” will work, whereas “OK Google,
open motor drive” may not trigger
anything.
