Avid Technology VENUE S6L, Быстрый старт

Страница: 8 / 11

Replacing the MTS 8
3
Pushing gently from the back, carefully free the MTS from the chassis and set it face down on the towel or other padded surface
you placed over the module directly below it.
• Be very careful to not stretch any cables (they are long enough to allow the MTS to be tilted forward and set face down).
• 24C Only: Be careful to not set the MTS on the chassis Top Cover you removed earlier.
Disconnect the Old MTS
The MTS has three cable connections:
• Multi-strand Backlight cable ( 1 in Figure 11)
• Touch-controller cable (
2
in Figure 11)
• LVDS ( 3 in Figure 11)
Your replacement MTS includes new Backlight and Touch-controller cables pre-installed. As shown in the following instructions,
you must detach the LVDS cable from the old MTS, then disconnect the Backlight and Touch-controller cables from within the
chassis and remove them along with the old MTS.
Follow the instructions below carefully to make sure to correctly replace and connect cables.
To disconnect the LVDS cable from the old MTS:

Disconnect the LVDS cable ( 3 in Figure 12) from the back of the old MTS. Carefully chip off any glue that secures the cable to
its connector, and note how the cable is oriented (to simplify connection to the new MTS later).
Figure 10. Freeing the MTS from the chassis
Figure 11. Backlight (1), Touch-controller (2), and LVDS (3) cables
1
2
3