Avid Technology VENUE MADI, Руководство пользователя

Страница: 8 / 26

Chapter 2: Installing the MADI Card 5
12
Connect the included ribbon cable from the port on the
first (top) MADI card to the port labeled “FireWire” on the first
Mix Engine card, the innermost card when viewed from the
open front panel. Make sure that the notches on the ribbon
cable line up correctly with the notch on the ports, and that
each connector is connected securely. The MADI card con-
nected to this first Mix Engine card will appear as
MADI 1 in
the Patchbay.
13
If you are installing a second MADI card, do the following:
• Slide the card into the open expansion slot beneath the
first card.
– and –
• Connect the included ribbon cable to the port on the sec-
ond MADI card and to the connector labeled “FireWire”
on the second Mix Engine card, the card immediately ad-
jacent to the first Mix Engine card. The MADI card con-
nected to this second Mix Engine card will appear as
MADI 2 in the VENUE Patchbay.
14
Reattach the FOH Rack front panel faceplate
15
Reconnect power, audio, FOH Link, and any other cables to
the FOH Rack.
16
Proceed to “Confirming MADI Card Installation” on
page 9.
Mix Rack MADI Card Installation
This section shows how to install MADI cards into a Mix Rack.
If you are installing a second option card in the Mix Rack for
the redundant output configuration, follow these instructions
and then proceed to “Installing the Clock Source Jumper Ca-
ble” on page 7.
To install the MADI card in your Mix Rack:
1
Shut down your sound system.
2
Power down your Mix Rack.
3
Disconnect all power, audio, FOH Link, and any other cables
connected to the Mix Rack.
4
Remove the front panel faceplate by unscrewing its mount-
ing screws (#1 Phillips). Keep the screws nearby for remount-
ing the front panel later.
Connecting the ribbon cable to the MADI card
Connecting the ribbon cable to the first Mix Engine card
A single installed MADI card may be connected to the sec-
ond Mix Engine card, which will then appear on the system
as MADI 2. A second FOH Rack Snake card is required.
Front of the Mix Rack
Mounting screws (remove all)
Faceplate