Chapter 2
Setting Up a PortServer Workgroup
32
Connecting Cables to the MediaSwitch 16
The MediaSwitch 16 connects the PortServer system to the MediaNetwork
workgroup. Avid ships and supports the MediaSwitch 16. Avid also supports,
but does not ship, two types of exisitng MEDIASwitches: 1-Gb
MEDIASwitches (non-DNxHD) and 2-Gb MEDIASwitches. Explanations of
cable connections for these MEDIASwitches can be found in
of
this manual.
n
The MediaSwitch 16 should have been setup previously and connected to the
Avid Unity File Manager.
The 2-Gb MediaSwitch 16 uses small form-factor pluggable (SFP) connectors
to connect the cables to the switch.
Connecting to a 2-Gb MediaSwitch 16
The following procedure describes how to connect the optical SFP and optical
cable to the 2-Gb MediaSwitch 16.
To connect an optical cable to the 2-Gb MediaSwitch 16:
1. Locate the optical SFP in the PortServer kit.
2. Route the optical cable from the PortServer system to the
MediaSwitch 16.
Installing an SFP Connector
n
You can install the SFP while the MediaSwitch 16 is turned on.
a
a
SFP
Содержание SR2400
