Avid Technology S6L Control Surface, Замена

Страница: 8 / 31

S6L-24D, S6L-32D, and S6L-48D 8
7
Align the edge of the Tray with the edge of the chassis as shown in
Figure 11
so that the Tray hangs off the chassis.
3. Remove the SBC
After hanging the SBC Tray on the chassis you are ready to remove the shroud, disconnect and replace cables, then remove the old
SBC.
Removing the Shroud
Original Congatec S6L SBC assemblies included a purple plastic shroud, but current assemblies do not. If your system has a
shroud, do the following to remove it from the SBC tray and then recycle the shroud (you do not need to re-install it).
To remove the old shroud:

Using a #2 Phillips screwdriver, remove the purple shroud by doing the following (keep all fasteners organized to reuse later):
• Remove the screw that secures the front edge of the shroud to the Tray.
• Remove the two screws that secure the back edge of the shroud to the Tray.
• Remove and recycle the shroud and its fasteners.
The image shown below is of an older series control surface.
Figure 11. SBC Tray hung off the back edge of the chassis
Do not attempt to transfer the SSD from the old SBC onto the new SBC.
Figure 12. Removing screws that secure the front of the shroud (shown at left) and back of the shroud (one shown, at right)
S6L-24D/32D/48D