E6L Engine AVB-192 Network Card Replacement
6
Installing AVB-192 Cards
Re-install AVB-192 card(s) in the following sequence:
• Master 1 (lowest) slot
• Slot 2 (if re-installing a second AVB-192 Network Card)
• Slot 3 (if re-installing a WSG-HD or second MADI-192 card into an E6L-112 (only))
To re-install a Master AVB-192 card:
1
Pre-position the red and black AVB power cable: it must be below where you will be installing the slot 1/Master AVB-192 card
and above any WSG-HD card (E6L-192/144 only).
2
Place the face of the card into position in its slot (the lowest slot 1/Master AVB slot) with the back of the card tilting upwards.
3
Slowly move the back of the card downwards along the sheet metal until the card is horizontal.
4
Once the card is horizontal, make sure the tab on the faceplate of the Network card is positioned on the outside of the slot.
5
Align the PCIe connector on the card with the corresponding PCIe port, and align the flange on the card with the retaining clip
on the PC board.
6
Lift the tab on the retaining clip and press the card firmly into the PCIe port and clip.
7
When the card is properly seated in the slot, tighten the exterior captive thumbscrew to secure the faceplate of the card to the
back panel of the E6L.
8
Tighten the rear bracket captive thumbscrew to secure the back of the card to the back bracket.
Figure 13. Lowering the AVB-192 card into position
Figure 14. Inserting the AVB-192 card into its PCIe port
Figure 15. Securing the AVB-192 card to the back bracket
