Avid Technology AVB-192, Замена

Страница: 2 / 13

E6L Engine AVB-192 Network Card Replacement 2
5
Simultaneously pull the two bottom thumbscrews outward so the latches they are attached to are fully extended (see Figure 2).
6
Using the handle, slowly slide the core partially out, locate the interior catch on the right side of the tray, and press it to release
the core from the chassis.
7
Slowly slide the core out of the E6L chassis completely, and place it on your work surface.
E6L-112 Only
If your E6L-112 does not have a WSG-HD or MADI-192 MADI Option card installed, or if you are replacing AVB cards in
E6L-192 or E6L-144, skip to
Removing AVB-192 Network Cards
.
Before replacing one or more AVB-192 Network Cards in an E6L-112 (only) you must first remove any Option cards currently in-
stalled in Network slot 3 (either a WSG-HD Waves SoundGrid Option Card,
or a second MADI-192 MADI Option Card, if either
are present).
Removing a WSG-HD or MADI-192 Card from an E6L-112 (Only)
To remove a WSG-HD or MADI-192 card from an E6L-112:
1
WSG-HD Only: Disconnect the short Ethernet cables that connect the WSG-HD card to the AVB-192 Network Card(s).
• In E6L-112 engines with a single AVB-192 card, disconnect the WSG-HD card from the lower AVB-192 card (slot 1/Master).
• In E6L-112 engines with two AVB-192 cards, disconnect the WSG-HD card from the lower AVB-192 card (slot 1/Master).
Then disconnect the short Ethernet cable that connects the upper AVB-192 card to the lower AVB-192 card (slot 1/Master).
• Set the cable(s) aside (to re-install later).
Figure 2. Latches fully extended
Figure 3. Location of the interior catch
The core will not slide out of the E6L chassis until the latches are fully extended and the catch has been released.