INSTALLATION
(continued)
Step
2
:
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
Use an 8” round metal pipe (follow building codes in your area) to connect the exhaust on the hood to the
ductwork above, as illustrated in figure 4. Use duct tape to make all joints secure and air tight.
Step 3:
Drop oil tunnel into recess support near rear of hood.
See figure 8.
To install baffle filters and stainless spacer(s), refer to figure 9
and follow these five steps:
Angle filter toward back of hood.
Push filter up until almost level.
Slide forward into recess behind the front of hood.
Lower filter.
Slide back until it fits into resting position.
Step 4:
Turn power ON in control panel. Check all lights and fan operations.
Figure
8
Figure
9
27
