INSTALLATION INSTRUCTIONS (continued)
Install the support frame extensions onto the range hood body:
Fasten the adjusted support frame extensions onto the lower support frame using
“B”
screws and
“C”
washers as shown in
Figure 3. Each end of support frame extension should be installed with at least
(2) two “B” and “C” fasteners
. Repeat this step
for all the support frame extensions.
•
If your specific model does not have a lower support frame, then the support frame extensions will fasten directly
onto the range hood body, using the same
“B”
and
“C”
fasteners.
IMPORTANT
: Always use at least 1 bolt and washer set on each side of thesupport frame extensions, (2-sides on each)
on both ends (2-ends on each).
Install the duct tube ( not included)
Install and affix the duct tube onto the household ducting (or Air Diverter assembly) at the top of the chimney; extend the
ducting down and ensure there is approximately 6” of
ducting to install onto the vent ducting. Only use approved ducting tape
or fastening devices.
Partially install the chimney covers onto the range hood:
Position the chimney covers over the support frame extensions, resting onto the range hood. Ensure they are the correct
orientation as if they fully installed.
Install the support frame extensions and range hood
assembly onto the upper support
frame:
Have multiple people lift, hold and position the range hood
assembly (with chimney covers) to install the open end of
support frame extensions onto the upper support frame
(already installed into your ceiling). Fasten each extension
with
“B”
screws and
“C”
washers as shown in Figure 3.
IMPORTANT
: Always use at least 1 bolt on each side of the
support frame extensions, on both ends.
Connect the power plug:
Ensure there is no power present at the power outlet, plug in
the unit. Only use approved ducting tape or fastening
devices.
Affix the upper chimney cover onto the upper support
frame:
Using the "B" screws and “D” washers, separate, lift and
position the upper chimney cover over the upper support
frame, aligning the mounting holes, and then affixing the upper chimney into place.
Re-install grease filters and also remove all protective wrapping, and then check all range
hood functions.
Clean stainless steel surfaces with stainless steel cleaner
26
