Avery Dennison TTX 207, Руководство пользователя

Страница: 8 / 22

04/02 Rev. 2.15-01 MANUAL Setup, Operation, Service, page 8
TTX 207 – Da Capo
Maintenance and care
Carefull and regular maintenance will raise the performance and longevity of
the printer, especially that of the printhead. Generally regard: Keep any dirt
out off the print module! Remove any deposits of paper, adhesive and pre-
print colors off the printhead, feed roller and gap sensor periodically.
Changing and cleaning the printhead
1. Switch unit off and pull off mains plug!
2. Open pressure lever.
3. Remove material.
Disconnect printhead plug after at least 3 minutes from switching off the unit!
4. Unscrew knurled screws at printhead holder and remove.
5. Draw out the printhead carefully.
6. Clean print head with dust-free cloth and cleansing liquor only.
Metal objects must never get into contact with printhead surface! Never use
knives or objects with sharp edges for cleaning.
7. Proceed assembly of printhead in reverse order.
Special care is to be taken that printhead is supported flush on holding plate
and completely flush towards the guide mechanism (looks like a tooth)
(Fig.
4) to warrant inprint according to the O-line as well as damages of the prin-
thead.
Fig. 4: The print head must cling thightly to its holder (upper figure).