Avery Dennison TTX 207, Руководство пользователя

Страница: 5 / 22

04/02 Rev. 2.15-01 MANUAL Setup, Operation, Service, page 5
TTX 207 – Da Capo
Insertion/removal of material
1. Hang document material in reel holder in a way to ensure anticlockwise
unwinding.
2. Open pressure lever (red).
3. Insert material underneath the printhead according to sketch, further mate-
rial transport is automatically.
4. Close pressure lever.
5. When using notched material, adjust gap sensor to the gap position.
At a material width less than 65 m the thrust screw (Fig. 2) has to be tighte-
ned.
6. Switch „ON“ printer - the green LED glows at the operation panel (eventually
switch to OFFLINE). By depression of the FEED-key a material feed can be
advanced. At punched material one label length is advanced, continous
material is transport as long as FEED-key is operated.
Removal of material Material can be removed after opening the pressure lever.
Fig. 2: Material winding diagram.
CAUTION!
Danger of pulling in and tearing off of hair, jewellery, loose clothing, etc.!
– Don´t let long hair, loose sleeves, jewellery, etc. hang into the printer!