Avery Dennison Power Stacker, Руководство пользователя

Страница: 10 / 39

User / Service Manual Power Stacker
10/06 Rev. 1.09
10
Adjusting the label width
To be sure that the stacker is working properly – the width of the expected label has to be
adjusted on the power stacker.
Attention: Never use the exact label width – adjust always 1 –2 mm more to the guiding.
The label should never be squeezed – but secure guided.
The media width is adjusted with a guiding witch is movable in both directions (see picture) it
can be moved on a axle to the different width of the label.
The moving parts of the guiding are used to adjust the guiding to the different sensor 8short
label – long label).
Adjusting the label length
As the label width – the label length has to be adjusted. The reason for is the speed of the
label after leaving the printer. The label is not falling down – it is moving with the same speed
the printer has used. So we have to stop the label in the right position to form a stack looking
properly.
Therefore the label stopper is used. Two different units are used with the poser stacker – one
for short label (not longer then the cover) one for longer label – sticks to the platform itself.
Both are delivered with the power stacker. Please take care that you do not squeeze the
label.
Stopper