Avery Dennison Monarch ADTP1, Руководство системного администратора

Страница: 67 / 94

Classification: Avery Dennison – Public Setting RFID Options 8-13
Setting the Verify Power
This option only appears in the Advanced Setup menu. The verify power setting increases
the strength of the RF Field emitted by the printer’s antenna. Use this power to read a
programmed tag. The range is -15 to 23. The default is -15.
Use the lowest power possible to avoid any interference with the internal antenna.
Interference may occur between the external verifier and internal antenna because of
their close proximity.
Use the
RFID Printer Setup Utility
to determine the verify power then enter the value at
the printer.
Select To

Decrease the setting. If the verify power setting is too low, the RFID
inlay in the verifier’s field may not be read.

Increase the setting. If the verify power setting is too high, adjacent
RFID inlays may be read.
Press 1 to toggle the amount (1, 10, or 100).
Setting the Tag Verify Position
This option only appears in the Advanced Setup menu. The tag verify position is
only
used when Verify is set to external or both . Sets the position for when the label’s leading
edge reaches the external verifier. The range is 10 to 2000. The default is 100.
If you continuously receive error 748 (verify mismatch) or 749 (RFID verify fail), adjust
the tag verify position.
Use the
RFID Printer Setup Utility to determine the tag verify position then enter the
value at the printer.
Select To

Decrease the setting.

Increase the setting.
Press 1 to toggle the amount (1, 10, or 100).