Avery Dennison MONARCH 939I, Руководство по эксплуатации

Страница: 24 / 32

C-2 Operating Instructions
Operating the Sca nner
CAUTION
Do not stare into the beam.
To scan a bar code:
1.
Point the scanner at a slight angle to, and approximately four to eight
inches from the bar code symbol.
2. Press the button on the scanner. W hen the scanner is in the stand, it
automatically scans any bar codes held in front of the scanner’s
window. Make sure you do not scan data twice or accidentally scan
the wrong data.
Troubleshooting the Scanner
If the bar code does not scan:
♦
Change the scanner’s angle slightly and try again.
♦
Move the scanner four to eight inches away from the bar code. Adjust
this distance as needed to find the correct distance.
♦
Try scanning another bar code that you have scanned successfully. If
that scan is successful, the scanning problem may be with the bar
code.
♦
Move to a more dimly lit area.
♦
Ensure there are no voids (streaks) in the bar code symbol.
♦
Clean the scanner window. See “ Cleaning ” for more information.
♦
If the scanner stays in the same place without scanning anything for
awhile, the scanner may appear to “time out.” If this happens move
the scanner slightly and then towards the bar code you want to scan.
The scanner should scan the bar code. Make sure you do not scan
data twice or accidentally scan the wrong data.
♦
Before you call Service, print a set of test labels. The test labels
contain information to help Service diagnose mechanical and setup
problems. To print a set of test labels, press
F1 when you see “Print
Mode Ready.”