avertX HD300, Руководство пользователя

Страница: 10 / 26

10
AvertX HD300 cameras use Power over Ethernet (PoE). The only
connection on the camera is the RJ45 Ethernet dongle located on the
rear of the camera. Connect one end of an Ethernet cable to the dongle,
and connect the other end to the HDIP recorder, or to a PoE switch.

Protect the network cable connection from water damage by
running the cord inside a wall or ceiling, or through conduit.

If passing the cord throug
h a wall or ceiling, drill a 7/8” hole.

For outdoor installations, seal any holes in the wall or ceiling
with silicone caulk to protect against water intrusion.
AvertX recommends using Category 5 Ethernet cable (CAT5e) to
connect the camera to your network. The cable length should not
exceed 328 feet (100 meters).
Once you have connected the camera, check the status of the network
connection by looking at the link indicator and activity indicator LEDs. If
the LEDs are not lit check your network connection. The green link LED
indicates a network connection and the orange activity LED flashes to
indicate network activity.