3.5. Screen programming.
!!! NOTICE !!!
The screen was programmed properly at the factory and there is no need to reprogram it without any important
reason. Setting of screen extreme positions was made by manufacturer.
If you need to change the screen extreme position follow the instructions described below.
Picture 10 Screen without remote control system
electric installation
Screen
bl - blue (common)
br - brown (rolling up)
yg - yellow-green (protective)
bk - black (rolling down)
Power line
L1 - brown (live)
N - blue (neutral)
G - yellow-green (protective)
bl
yg
bk
br
Programing the length of the rolled out screen (screen bottom bar position).
- Roll up the screen until it will stop automatically in the upper position.
- Insert regulation wrench included in the screen set into the regulation slot (see picture. 11) located in the left bottom
part of the screen .
Regulation knob “2” (bottom/back) enables setting of the bottom extreme position of the screen bottom bar:
„+” - increase the length of the fabrics is rolled down when the screen is rolled out,
„–” - decrease the length of the fabrics is rolled down when the screen is rolled out.
Regulation knob “1” (top/front) enables setting of the top extreme position of the screen bottom bar:
“-“ - increase the lenght of the fabrics is rolled down when the screen is rolled in,
“+” - decrease the length of the fabrics is rolled down when the screen is rolled in.
~
Picture 11 Lower bar fine tuning
10
IMPORTANT!
Do not decrease (tuning knob 1+) the range of the rolled down surface. It can damage the screen.
Do not increase (regulation 2+) the range of the surface which was rolled down behind the STOP mark, placed in
the upper right corner of the screen. Rolling down the screen behind the mark can damage the screen.
Avers screens are invented and manufactured to provide best possible projection surface flatness when rolled out
to the designed height. Surface flatness would be affected if the screen is not rolled out completely or is rolled out
over the designed size.
