8.1.1.3 Alarm/Sensor Setup
(1)
(2)
(3)
(1) Alarm Setup
-
Mail Alarm Enable
Enable/disable alarm sending mail when alarm has triggered or motion has detected.
i
The Motion Detection must be enabled first, the alarm sending mail will send out the mail
when detect motion.
-
Alarm Out Time
Set the amount of time (in second) to continue sending the alarm once activated
(2) Sensor Setup
-
Sensor Status
Customize the initial state of the attached sensor for every camera. Refer to the table
below to customize the sensor state.
Not installed:
Indicates that there is no sensor connected
Normal open:
Indicates that the initial state of the sensor is normal open. Video
recording initiate when there is a changes in the sensor state
Normal close:
Indicates that the initial state of the sensor is normal close. Video
recording initiate when there is a changes in the sensor state
-
Sensor Record Time
Set the amount of time (in second) to record after the sensor has been triggered
(3) E-Mail Setup
-
SMTP
Enter the SMTP server
-
User ID & Password
Enter User ID and Password for e-mail server user identification
-
From
Enter the sender e-mail address
42
