50AER10-20
TV Setup
Initial Setup Wizard
STEP 3: Setting Air/Cable and Channel Auto Scan
Use the
arrow buttons to select Air or Cable based on your
type of connection (Antenna or Cable without a set top box).
For Antenna & Cable Connections WITHOUT a set top box:
Use the
arrow button to select Go to next step and press the
button to begin the Channel Auto Scan.
Note: Your type of television connection will determine if you should complete the
Channel Auto Scan part of this step.
Channel Auto Scan may take several minutes to complete.
For Cable/Satellite Connections WITH a set top box:
Press the MENU button on the remote control to exit the Setup
Wizard.
NOTE: You will see the message “PLEASE RUN AUTO SCAN”
on the screen. Ignore this message as this is not necessary
when using a set top box.
Press the INPUT button on the remote control to display the
Input Source screen illustrated to the left.
Use the
arrow buttons to highlight the input where the
set top box was installed. Press ENTER to select the desired
input.
Once Channel Auto Scan has ended, Initial Setup is
complete. You may now begin enjoying your TV, or
make further adjustments to the TV settings which are
explained in the following pages of this manual.
Initial Setup is now complete. You may now begin enjoying your
TV, or make further adjustments to the TV settings which are
explained in the following pages of this manual.
Next
IMPORTANT NOTE: If your TV is connected to a Cable or
Satellite set top box DO NOT run the “Channel Auto Scan”
in STEP 3.
Setup Wizard
Go to next step
Select the antenna type then auto scan
Cable
Select
Move
Return
MENU
Air / Cable
Setup Wizard
Exit
MENU
Total Found : 0
Analog :
0
Digital : 0
RF CH : 2
Media
S o u r c e S e l e c t
Component / AV
HDMI 1
HDMI 2
HDMI 3
PC
