43
The example below shows the Live Camera View A is fully covered within the area of Preset 3,
when two people are detected by the camera, the Multi-Presenter Detection will be triggered.
While for Live Camera View B, the left part of the live view is not covered within the area of
Preset 3, therefore, even though there are two people showing in the live view, the Multi-Presenter
Detection will not be triggered.
2. On the
Presenter
setup page (
Tracking Settings
>
Presenter
), select the pre-configured preset
position (e.g. Preset 3) from the
Multi-Presenter Detection
drop-down list, the Multi-Presenter
Detection function has been enabled.
You can optionally change the dwell time for the camera to switch from multi-presenter detection
to single-presenter tracking when the detected presenters have been decreasing from multiple to
one. By default, the dwell time is set up with 3-sec. To change the dwell time, slide the bar of
Time
of Return to Tracking Point
to adjust the value.
3. When the
Presenter
tracking function is turned on, the Multi-Presenter Detection will be activated.
To turn on the
Presenter
tracking, refer to Step 3 in the <Presenter Mode> chapter.
4. If you want to disable the Multi-Presenter Detection function, on the
Presenter
setup page
(
Tracking Settings
>
Presenter
), select
Off
from the
Multi-Presenter Detection
drop-down list.
Preset 3
Live A
Live B
Multi-Presenter Detection will not be triggered
Multi-Presenter Detection will be triggered
Содержание PTC310HWV2
