Page|9
www.avenview.com
7.
INSTALLATION
To setup Avenview SDI-SPLITPRO-4S follow these steps for connecting to a device:
1.
Mount or fix the SDI-SPLITPRO-4S safely
2.
Switch off SDI-SPLITPRO-4S and all source devices and displays that will be connected
3.
Connect a monitor, projector and any HD displays that come with DVI / HDMI inputs by using 1 male –
male DVI cable to SDI-SPLITPRO-4S DVI output. (you can connect 2 displays equipped with DVI and
SDI.
4.
Connect FOUR (4) devices equipped with SDI output (such as broadcast camera) which can output
3G/HD/SD video signals to the BNC input connectors
to the SDI connector on the rear of the unit.
5.
Connect your computer to SDI-SPLITPRO-4S via RS232 cable and then install the software
6.
Turn ON SDI-SPLITPRO-4S
7.
Run the Control Software and establish the connection between PC and SDI-SPLITPRO-4S
8.
Turn ON all connected devices and then control the display output thru RS232 and included software
8.
INSTALLATION
1.
The SDI-SPLITPRO-4S provides a software control program which runs under Microsoft Windows 98,
2000, XP, Vista, 7 through the interface of RS-232 serial control.
2.
Before you click on the icon of the software, make sure you have secured the connection between your
computer COM port and the SDI-SPLITPRO-4S.
3.
Install driver for RS232 to USB adapter
4.
Once SDI-SPLITPRO-4S is turned on, it display green LED light
Ensure that correct driver for RS232-USB Adapter (included with SDI-SPLITPRO-4S/K) is
installed.
You can check “Device Manger” under “Ports” page to check if drivers are installed
correctly.
