Avenview FO-HDM2-T4K-R, Руководство по эксплуатации продукта

Страница: 13 / 24

The Setting button can be pressed in different combinations based on what is needed. The status light on the front
will flash based on the selection. The selections are in series, meaning, for example, if you are on selection 5
(listed below), you can come back later and press it again to move you to 6, 7, 8, 1, 2, etc. The indicator light is
directly next to the button.
4.1 TRANSMITTER - DEVICE FUNCTIONS
The IR mode slide switch on the front of the FO-HDM2-T4K-S transmitter is used to select the preferred IR mode.
The two modes are listed below, please note the default mode is IR-EYE:
1. IR-EYE - The IR Input will be configured to operate with an IR Receiver Eye.
2. I-PASS - The IR Input will be configured to safely operate with a direct connection from a
control system using a mono or stereo 3.5mm cable with a specifcation of 3v-20v.
4.1.2 - IR Mode
EDID Management: Quick press to select EDID.
1. EDID BYPASS --- LED Flashes 1 Time (Default, from downstream device)
2. 1080P_2CH --- LED Flashes 2 Times
3. 1080P_8CH --- LED Flashes 3 Times
4. 4K60HzY420_3D_2CH --- LED Flashes 4 Times
5. 4K60HzY420_3D_8CH --- LED Flashes 5 Times
6. 4K60Hz_3D_2CH_HDR--- LED Flashes 6 Times
7. 4K60Hz_3D_8CH_HDR --- LED Flashes 7 Times
8. USER EDID --- LED Flashes 8 Times
4.1.3 - Setting Button
4. INSTALLATION
This product is composed of a Transmitter and a Receiver.
The Transmitter should be connected to the source (Computer’s HDMI Port/IR Signal/RS-232) and the
Receiver should be connected to the HDMI of the digital display device (Monitor/TV). Avenview
FO-HDM2-T4K-SET Transmitter / Receiver is designed to be used with SC type standard optical cable
(Multi-Mode or Single-Mode optical fiber)
10
Rev.00 03/2018
www.avenview.com