G3 Series Wireless ARM Quick Start Manual
16
TDG3ARMQS1-1EN 03/21
Subject to change without notice
www.Emerson.com
Option 1 – Authentication via the G3 Graphic Display:
Once 2FA has been initiated through the Wireless ARM webpage, the Graphic Display on the G3 Communication Module will
read “ENABLE WIFI OUTPUTS”. To complete the 2FA process and enable output forcing, click the SET button on the module.
The display will then flash the message “WIFI OUTPUTS ARE ENABLED” for several seconds.
Once “WIFI OUTPUTS ARE ENABLED” stops flashing the graphic display will show the option to “DISABLE WIFI OUTPUTS”. To
exit Output Forcing mode you may either press the SET button on the G3 Communication Module, or turn Output Forcing off
using the Wireless ARM webpage.
On the Wireless ARM webpage the blue button text will now read “ACCEPT”. Click this button to continue with Output Forcing
turned on. Output Forcing will remain on until it is turned off via the Wireless ARM webpage or the G3 Graphic Display, or until
the WIFI connection with the ARM is terminated.
ENABLE
WIFI OUTPUTS
WIFI OUTPUTS
ARE ENABLED
DISABLE
WIFI OUTPUTS
