page 6 User guide MX-8
enable programming for any application and make them available to the user at
the touch of one’s fingertips.
For each preset, the following 3 parameters are programmed:
•
the master volume
•
which of the 4 outputs are to be active
•
a preset name. This way the different settings are immediately
distinguishable.
3.2 Changing between presets
•
Turn the unit on with the main on/off switch in the back.
•
The welcome message will appear in the display. After a few seconds, it
will disappear again and the settings of the current preset will show up.
Below, an example is given.
•
Here one can see the current preset name (in this case „Sonntag“) as
well as the value of the master volume in percent (total output volume,
here 70%). The bar above the preset name is an analogue
representation of the master volume.
•
On the right-hand side of the display the four little squares represent the
4 outputs (the numbers 1 through 4 are written above and below the
display). A dot within a square indicates, that this particular output is
active.
•
Please note: The preset settings can be guarded against accidental
changes. In this „preset protection mode“, changes can only be
undertaken by pushing and turning a knob at the same time.
•
In order to switch from one preset to another, push the preset knob
while turning it until the desired preset shows up in the display; then let
go. Now, all is set for the next application.
3.3 Temporarily changing an existing preset
•
Should it become necessary to change the volume of a given preset,
push the volume knob (only necessary in the preset protection mode)
while turning it to set the desired value. This change is only temporary,
i.e. once the unit is turned off and back on again, the original preset is
active again.
•
Should it become necessary to temporarily change the active outputs,
then briefly push both knobs at the same time. By pushing the preset
knob, the display will successively show each output. The respective
name of the output will appear (in the example given below „SchiffV“) as
