Avdel HP21, Инструкция по эксплуатации

Страница: 4 / 24

4
Safety
1
Do not use outside the design intent.
2 Do not use equipment with this HydraPac other than that recommended and supplied by Avdel UK Limited.
3 Any modification undertaken by the customer to the HydraPac shall be the customer’s entire responsibility.
4
Always disconnect the HydraPac from the power supply before attempting any work.
5 The HydraPac should always be positioned on a flat stable surface.
6 It is recommended that the HydraPac only be started with hoses and an installation tool attached.
7 Do not fit flexible hoses rated at less than 10 000 psi (69 mPa).
8
The operating pressure shall not exceed 8000 psi (55.2 mPa).
9 Take care to avoid entanglement of the trailing cable with any object on the floor.
10 The HydraPac should be kept clean for safe and easy operation.
11 When moving the HydraPac from place to place only pull on the handle, not on the hoses.
12
Ear protection must be worn by the operator and others in the vicinity utilising lockbolt installation tooling as noise levels for these tools
exceed the permitted maximum. For these values see the installation tool technical manuals.
This instruction manual must be read with particular attention to the following safety rules, by any person
installing, operating, or servicing this tool.
CAUTIONS
AVDEL RECOMMENDS THAT ONLY HYDRADRIV TOOLING BE USED WITH THE HYDRAPACS AS OTHER MAKES OF HYDRAULIC
TOOLING MAY NOT OPERATE AT THE SAFE DESIGNED WORKING PRESSURES.
KEEP DIRT AND FOREIGN MATTER OUT OF THE HYDRAULIC SYSTEMS AS THIS WILL CAUSE THE HYDRAPAC TO
MALFUNCTION.