Avdel AVBOLT, Инструкция по эксплуатации

Страница: 51 / 56

23
Fault Diagnosis
IMPORTANT - Only fully trained and qualified hydraulic technicians should service the pump or system components.
Please contact Avdel for your servicing, repair and training requirements. Service Instructions and repair parts sheet
are available on request.
SYMPTOM POSSIBLE CAUSE REMEDY PAGE REF.
Fault condition
Refer to Pump LCD Menus and
Operating Instructions and Fault
Conditions for details 13 to 17, 25
Incorrect power supply
Check power supply against
specification
7 to 9
Trigger control cable not
connected correctly
Check control cable is correctly
connected at pump and placing
tool
11, 12
Pump/Motor will not
start
Damaged trigger switch
Refer to placing tool Instruction
manual for repair/replacement
Pump in local mode
Turn off Local Mode - Refer to
Pump LCD Menus and Operating
Instructions 16
Refer to Diagnose Menu 17
Trigger Button does
not function
Trigger, control cable or
connector damaged
Refer to placing tool Instruction
manual for repair/replacement
Hydraulic Hoses not connected
Check for correct connections at
pump and placing tool
11, 12
Faulty hydraulic quick couplers
Replace quick couplers - refer to
placing tool instruction manual
Low oil level
Add oil - refer to Putting into
Service and Maintenance and
Servicing
11, 12, 21,
22
External system leak Inspect and repair or replace
Internal leak in pump See authorized service center
Internal leak in valve See authorized service center
Motor running but
placing tool does not
function
Internal leak in system
component
See authorized service center
Low voltage Refer to Fault Conditions 25
Turn off other electric loads
Motor stops under
load
Use heavier gauge extension cord
No power or wrong voltage
Connect to correct power source
per pump name plate &
specification 7 to 9
Solenoid cable disconnected or
damaged
Connect, repair, or replace cable
Solenoid valve will not
operate
Valve out of adjustment See authorized service center