Avaya WAP9112, Установка

Страница: 2 / 3

WAP 9112 Installation
2
3. Connect the cables as follows. Plug the Uplink-PoE and Pass-through cables into their respective sockets as
shown in
Figure 2 (A). If the cables are not fitted with RJ45 jacks, they can be connected to the punch down
blocks using a dedicated network cable tool according to the sequence of colored wires marked on the back of
the AP, as shown in
Figure 2 (B).
4. Move the AP into position against the bracket. Make sure that the locking tab mates with the locking slot as
indicated by the dotted line in
Figure 2 (A). Secure the AP to the mounting bracket using the locking screw, as
shown in Figure 2 (C). The screw should be tightened to not more than 20Kgf and care should be taken not to
damage the equipment.
5. If you have not supplied power via PoE, use a local 48 VDC power adapter
(meeting the specifications on Page 1) as shown in
Figure 3 .
6. When the correct power is supplied, the POWER LED on the side of the unit
lights, and the WAP 9112 boots up.
Locking slot
Uplink PoE
Pass-through
Figure 2
A
B
C
Install
Locking Screw
Locking tab
Figure 3