Avaya P332MF, Руководство пользователя, Страница: 117 / 182

Chapter 6 CLI – Layer 2
Avaya P332MF User’s Guide 101
set port speed
Use the
set port speed
command to configure the speed of a 10/100Base-T
port. If autonegotiation mode is enabled for such ports, the port's speed is
determined by autonegotiation, and an error message is thus generated if you
attempt to perform the
set port speed
command in this case.
Note: This command does not apply to P332G-ML and P332GT-ML ports. An error
message is generated if you attempt to perform the
set port speed
command
for P332G-ML and P332GT-ML ports.
The syntax for this command is:
set port speed <mod_num>/<port_num> {value}
Output Example:
To configure port 2 on module 2 port speed to 10 Mbps:
P330-N# set port speed 2/2 10MB
Port 2/2 speed set to 10 Mbps.
set port duplex
Use the
set port duplex
command to configure the duplex mode of a
10/100Base-T port. You can configure the duplex mode to either Half or Full
duplex. If autonegotiation mode is enabled for such ports, the port’s duplex mode is
determined by autonegotiation, and an error message is thus generated if you
attempt to perform the
set port duplex
command in this case.
Note:
P332G-ML and P332GT-ML switch ports work in Full duplex mode only. An
error message is generated if you attempt to change P332G-ML and P332GT-ML
ports to
half-duplex
.
The syntax for this command is:
set port duplex <mod_num>/<port_num> {full|half}
Example:
To set port 1 on module 2 to full duplex:
P330-N# set port duplex 2/1 full
Port 2/1 set to full-duplex.