Avaya IP Office TransTalk MDW 9040, Инструкция по установке и эксплуатации

Страница: 72 / 118

5
Programming & Using the MDW 9040 Pocket Phone Setting or Changing Handset Settings
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
64
Issue 2, February 2001
Performance / Range
Test in Wireless Test
Mode
Using the signal strength test and the voice quality test together, you can determine:
•
if the installation has been done correctly.
•
if the handsets and radio module(s) are working properly.
•
the range in which your MDW 9040 Pocket Phone performs best at your site.
Close Up Test
Note:
To properly test the installation, test with the handset antenna down
and place all handsets into Wireless Test Mode at the same time.
At no more than 5 to 10 feet (1.5 to 3.1 m) from its radio module, use the following
procedure:
1 Make sure the handset is turned off.
2 Enter Wireless Test Mode. See “ Using Wireless Test Mode ” on page page 61 .
The handset emits a simulated dial tone, which continues until you exit Wireless
Test Mode. The radio module LED signals flash in a unique pattern to identify the
test ports (Power LED = Line 1, Control LED = Line 2).
The Wireless Test Mode results screen displays.
For all sets, do the following.
3 Press the Softkey ( ) below Auto.
The display should show a
9
or
10
for signal strength (an occasional 8 is
acceptable) for both handset (H) and base (B).
The display should show a
9
or
10
for voice quality (an occasional 8 is
acceptable) for both handset (H) and base (B).
Individual set readings below 9 or 10 (an occasional 8 is acceptable) can illustrate
problems with individual handset/base combinations. If all set readings are below
these numbers, it could indicate problems with the installation or interference from
other 900 MHz devices.
SIGNAL: H= B=
VOICE: H= B=
POWER: H= B=
Man Auto Back