12
Wall Installation
Note:
For wall-mounting, you will need a 1-foot line cord. (This cord is
not
supplied with the telephone, but can be ordered by using this
comcode: 103786760.)
1. Make sure the 8-conductor wall mount plate is in place.
2. Place the telephone face down on a flat surface.
3. Remove the desktop stand which is attached to the base of the
telephone by tabs on the top and back of the stand, shown as
2
and
6
in Figure 4.
–
Press inward on the top of the stand until you can lift the upper tab(s)
of the stand (shown as
1
in Figure 5 below) out of the tab slot(s)
(shown as
2
in Figure 5 below) on the telephone.
–
Lift the bottom of the stand out of the lower tab slot(s).
FIGURE 5
Removing the Desktop Stand
4. Snap the line cord into the “LINE” jack in the bottom of the telephone.
5. Reverse the desktop stand so that the larger end is facing down and
coil the excess line cord in the back of the deskstand.
6. Engage the upper tabs (
1
in Figure 5) of the deskstand into the slots
(
4
in Figure 5). Slowly lower the reversed deskstand onto the bottom of
the telephone until the lower tabs (shown as
3
in Figure 5) snap into
the appropriate slots on the bottom of the telephone (
2
in Figure 5).
7. Install two screws (#4-24 (M2.9X1) self-threading, length of 0.375”
(9.5mm)) to fasten the base to the bottom of the telephone. See Figure
6 for the location of the two areas in which these screws must be
installed. Available in a kit for three telephones (PEC 33106).
8. Place the free end of the line cord through the opening in the middle of
the deskstand and then snap the free end of the line cord into the wall
jack.
2
1
2
4
3
R
Re
