3600 Series Wireless IP Phone Installation
3600 Series IP Phone Installation
Page 6
IP Office 4.0
15-601082 Issue 05a (22nd May 2007)
Overview of the AVPP
The AVPP is connected to the same LAN sub-net as the wireless access points being used for wireless
phone operation. The AVPP requires a Cat. 5 cable connection between its network port and the
Ethernet switch. The AVPP auto-negotiates to the type of port on the Ethernet switch and supports
10Base-T, 100Base-T, full-duplex and half-duplex port types.
AVPP Type Simultaneous
Calls per AVPP
Maximum Number of
AVPP's on Network
AVPP010
10 4
AVPP020
20 2
AVPP100
80* 16
•
*With the AVPP100 the maximum simultaneous calls per AVPP varies with the number of
AVPP's on the network.
•
The AVPP's within a network must be all be the same type.
•
The AVPP measures approximately 4 x 12.5 x 7 inches, and weighs about five pounds. The unit
can be wall mounted, vertically or horizontally, over ¾” plywood.
•
The AVPP can also be rack mounted using a rack mount kit (sold separately).
•
Initially the AVPP requires configuration via a serial port connection. However once basic
administration has been performed, further configuration can be done via Telnet access across
the LAN.
In a system comprised of multiple AVPP's using an IP protocol, a master AVPP must be identified. The
master AVPP server must have a static IP address. The wireless phones and the other AVPP's locate
the master by using a static IP address, DHCP, or DNS.
The loss of a non-master AVPP does not significantly affect the operation of the remaining AVPP's.
However, the loss of the master AVPP results in a loss of all communication between all of the AVPP's.
This also means that the loss of the master AVPP results in the loss of all active calls and wireless
phones cannot check-in until communication with the master is re-established.