17
GAS CONVERSION
SETTING THE BURNER MINIMUM SETTING
When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when
passing suddenly from maximum to minimum flame.
The following process applies to the following models:
GR2011CW / GR2012CB / GR2013CSS GR2414CW / GR2415CB / GR2416CSS GRO20P0W / GRO24P0W
1)
Light the burner.
2)
Set the top burner valve to the minimum position.
3)
Remove the knob by pulling straight out.
4)
Locate the bypass screw (see illustration).
Single valve stems are hollow, the bypass screws is
located inside the stem.
Insert the flat head screwdriver (2.5mm x 75mm) into the
stem center and turn the bypass screw clockwise to adjust
the flame.
DO NOT OVERTIGHTEN.
5)
Replace the knob.
6)
Repeat for each of the other burners.
The following process applies to the following models: DGR20P3S / DGR24P3S (COOKTOP)
1)
Light the burner.
2)
Set the top burner valve to the minimum position.
3)
Remove the knob by pulling straight out.
4)
Locate the bypass screw behind the left screw (see
illustration).
Remove the left screw.
Insert the flat head screwdriver (2.5mm x 75mm)
Into the screw hole and turn the bypass screw clockwise
to adjust the flame.
DO NOT OVERTIGHTEN.
5)
Replace the knob.
6)
Repeat for each of the other burners.
OVEN BURNER SETTING:
The following process applies to the following models:
GR2011CW / GR2012CB / GR2013CSS
GR2414CW / GR2415CB / GR2416CSS
GRO20P0W / GRO24P0W
DGR20P3S / DGR24P3S
1)
Light the burner by turning the thermostat to
the 500ºF position,
2)
Remove the knob by pulling straight out.
3)
Remove the two (2) Philips head screws that
secure the LED light board and ring to the
control panel.
4)
Carefully lift the ring and LED light board
away from the control panel to allow access
to the access hole below the valve stem.
(see illustration).
5)
Insert the flat head screwdriver (2.5mm x
75mm)
Into the screw hole and turn the bypass screw
clockwise to adjust the flame.
DO NOT OVERTIGHTEN.
6)
Mount the knob to the valve stem.
7)
Allow the oven to heat up for approximately 10 minutes then rotate the knob to the 300ºF position to operate the
thermostat by-pass.
Slowly screw the by-pass screw until you obtain a flame of approximately 3 – 4 mm in height.
8)
Carefully replace the ring, LED board and knob ensuring not to damage the LED board and wires.