Figure 2
Figure 3
Figure 1
2. Remove the rubber closing caps from the mounting screws as in the indicated positions. Remove the screws. See figure 2
and 3.
3. Turn the wire guard until the edge of the wire aligns with two indentation markers on the fixed rear guard. See figure 4.
4. Remove the cap and mounting screw in the indicated position. See figure 5.
Figure 5
5. Ensure that all rubber caps are fitted properly into the screw heads. See figure 6.
User Manual
www.AvantcoEquipment.com
5
1. To remove the wire guard adjust the position to align the edge of the wire guard with the single indentation marker on the
fixed rear guard. See figure 1.
REMOVAL AND REFITTING INSTRUCTIONS MIXER SAFETY GUARD
Figure 4
6. To replace the wire guard after cleaning repeat the instructions above in reverse.
Figure
6