User Manual
18 www.AvantcoEquipment.com
User Manual
18
www.AvantcoEquipment.com
User Manual
2
www.AvantcoEquipment.com
Index
Parts Overview ..............................................................
3
Standard Accessories
....................................................
4
Operation Instructions
..................................................
4
Figure 1: Gear Axle
........................................................
5
Figure 2: Initiative Axle
..................................................
6
Figure 3: Fork .................................................................
7
Figure 4: Change Speed Axle
........................................
8
Figure 5: Turning Plate and Mixing Axle
.......................
9
Figure 6: Single Phase Motor Diagram
.......................
10
Figure 7: Center Axle
...................................................
11
Maintenance and Protection
........................................
12
Troubleshooting ...........................................................
13
Warranty Information ...................................................
13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
injury.
8. Do not use outdoors
9. Keep hands, hair, clothing, as well as spatulas and other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to the mixer.
SAVE THESE INSTRUCTIONS
Cleaning
...........................................................
13
Troubleshooting
- 20_EN -
04/2010
7.
Trouble Possible Causes Solution
User Manual
13
Troubleshooting
Trouble
Possible Causes
Solution
The axles can’t work when
operating the machine
Poor contact of the electrical
equipment
Check the Plug
The mixing bowl is out of position
Moving direction is not correct
Change
Leaks oil
Sealing washer is damaged
Change
Difficult to move the bowl up and down
Slideway is rusted
Clean the slideway and lubricate
The motor is overheated
and speed is down
The voltage is not enough, or
incorrect speed
Check the voltage or use
lower speed
Noise and overheating
Poor lubrication
Add or change lubrication
Mixer touches bowl
The mixing device or bowl de -
formed
Repair or change the bowl
or mixing device
-
-
Limited Warranty
All equipment, which is sold under Avantco trademark and used for commercial purpose is warranted against defects in
materials and workmanship. The warranty runs for
six months
from the
time of purchase
and is for the benefit
of the original purchaser only. All other Warranties, Expressed or Implied, Statutory or Otherwise, including Without
Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded. The Seller shall in no event be
liable for direct, indirect or consequential damages in connection with Avantco commercial products.
This warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of proper set
– up, supervision when required or if the equipment is installed or operated in any manner contrary to the installation
www.AvantcoEquipment.com
Cleaning
before changing speed in order to avoid damage to the gear bo
DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CLEANING.
!
All new mixer bowls and accessories including, whips, beaters and dough hooks should be properly washed before use.
Wash with hot water and a mild soap solution and then rinse off with either a mild vinegar or soda. solution and then rinse again with
clean water. It is highly recommended this cleaning procedure is followed for bowls and accessories prior to whipping egg whites or
whole eggs. The mixer should be cleaned daily with a clean damp cloth.
If the unit has not been used for some time it is recommended that the procedure above is followed before mixer use.
It is important that the rear bowl lift guides are greased every three months to prevent corrosion.
WARNING:
19
- 20_EN -
04/2010
and operating instructions. In these cases, repairs will be made at a reasonable cost. Work performed by unauthorized
personnel or unauthorized service agencies voids this Warranty.
This warranty does not apply to, and Avantco is not responsible for any warranty claims on products sold or used
outside of the contiguous United States.
WWW.AvantcoEquipment.com
