AVANT e5, Руководство оператора

Страница: 46 / 96

Avant e5
46
.
Drive control
Principle of operation
The Avant e5 loader is equipped with a hydrostatic
drive system that is powered by an electric motor.
The drive pedals are used to control the motor and
the drive pump.

Use the pedals to control driving direction
and travel speed

Speed and pulling force are controlled with
the pedals. The more you press a pedal, the
faster the loader will travel, or the higher the
pulling force will be.

Choose the most suitable drive mode with
the drive/operating mode selection switch,
see page 47
The position of the Hand throttle lever controls only
the RPM of the auxiliary hydraulics system. Position
of this lever will not affect drive speed or pulling
force. The drive system works independently from
the other hydraulic circuits that are controlled with
the hand throttle lever.
When you do not actively use an attachment, keep
the hand throttle lever set to a low rpm setting to
conserve energy.
WARNING
Risk of collision or tip over - Use
low speed when you practise the
use of the loader. Familiarise
yourself with the driving of the
machine on low speed and on a
flat, even and open place. Make
sure that there are no persons in
the operating area of the machine
to avoid injuries that could result
from unintended movements.
When you have learned how to
drive with slow speed operating
mode, increase speed gradually
and learn how to drive and steer
the loader with higher drive
speeds.
WARNING
Risk of tipping over - Avoid high
speed turns. The loader can tip
over, if you turn the steering wheel
sharply while driving. Slow down
before making sharp turns. Always
control and steer the loader with
smooth movements.
Operator presence control
The loader is equipped with a safety system that
restricts the use of controls of the loader, if there is
no driver on the driver's seat. There are two
operating modes that are controlled with a switch on
the panel:
1.
When control mode switch is
switched to this position,
auxiliary hydraulics can be
operated while not seated on
the seat. Drive pedals are
disabled.
This makes it possible to
operate attachments that are
controlled with their own
control
systems. Those
attachments may be intended
to be operated from other
position than from the driver's
seat. See the intended use
and operating position from
the operator's manuals of
those attachments.
2.
In this mode, the drive pedals
boom movements and
auxiliary hydraulics can be
used only while seated on the
driver's seat
https://tractormanualz.com