AVANT A37265, Руководство оператора для насадки

Страница: 21 / 28

21 (28)
.
6.4 Material handling
Use maximum load indicated in the diagram of the operator’s manual of the loader as a guideline. Remember
that the actual load carrying capacity varies according to operating conditions, especially unevenness of
operating area has a great effect. Be especially careful when the load sensor indicator is activated. Also,
make sure that the ground surface is firm and follow recommended tire pressures.
WARNING
Risk of tipping over - Avoid overload by keeping the stump grinder close to the
machine while moving with the loader. Keep the stump grinder close to the ground
whenever driving, especially during turns and uneven terrain.
Pay attention that a
heavy load or long distance between the loader and the centre of gravity of the load will
affect the balance and handling of the loader. The use of additional counterweights is
recommended especially when operating smaller loader models. For 200-series loader
the wheel weights are recommended. With heavy loads, the telescopic boom must be
kept retracted while moving with the loader. Always wear seat belt.
6.5 Operating on inclined terrain
Extra caution is needed when using the equipment on inclined terrains and slopes. Drive slowly especially on
inclined, uneven, or slippery surfaces, and avoid sudden changes in speed or direction. Operate the controls
of the loader with careful and smooth movements. Watch out for ditches, holes on the ground, and other
obstacles, as hitting an obstacle may cause the loader to tip over.
Maximum lifting capacity can not be achieved on inclined terrain. On horizontally tilted terrain the load must
not be lifted high. The loader frame articulation should be kept straight when lifting heavy loads; turning the
load during lifting operation will affect the stability of the loader and may lead to overturning of the machine.
6.6 Operation with the tilt adapter
The attachment is not intended to be used with the tilting adapter fitted in between the attachment and the
quick coupling plate of the loader. The attachment must be coupled directly to the quick coupling plate of the
loader.