18(20)
7.2.
Adjusting the snow plow
The lower blade sections should be adjusted so that the frame
of the plow will not touch the ground.
To prevent wearing or damaging the
plow, the frame must not contact the
ground continuously. Adjust or replace
the lower blade sections before the
frame touches the ground.
7.3.
Servicing safety features
The lower blade sections will move during normal operation and their movement should not be blocked or
restrained. Do not over tighten the compression springs. If there are problems with the blade section tilting,
contact the service department. When handling the compressed springs, the hazards related to them must
be observed. Checking and adjusting the hydraulic safety relief valve must be left for authorized service
point, if there are any problems related to its operation.
The springs of the plow are tensioned and careless maintenance could lead to
serious injuries if the spring is released. Do not disassemble the tensioned springs of
the snow plow; leave the maintenance for professional service technicians.
8. Warranty terms
Avant Tecno Oy grants a warranty of one year (12 months) from the date of purchase for the attachment it
manufactures.
The warranty covers repair costs as follows:
•
Work costs are covered, if the repair is not performed at the factory.
•
The factory replaces any defective components or consumables.
The factory may reimburse the price of components purchased by the customer in special cases that have
been agreed in advance.
The warranty does not cover:
•
Normal maintenance work or parts and consumables required for it.
•
Damages caused by unusual operating conditions or ways of use, negligence, structural changes
made without the consent of Avant Tecno Oy, use of non-original parts or lack of maintenance.
•
Consequences of a defect, such as interruption of work or other possible additional damages.
•
Travel and/or freight costs caused by the repair.
NOTICE
