Avani SPC-2000, Руководство пользователя

Страница: 12 / 26

SPC-2000
AVANI Welding Fume Extractor
12
The Welding Fume Extractor is designed for
the filtration of smoke generated during
ordinary welding process work. When installed
and operated correctly, the machine will
effectively collect and screen the smoke
yielding a significant improvement in air
quality within the working environment.
1. Before starting the machine, be sure to
read this Manual carefully.
2. Before starting the machine, insure
that relevant safety protection
measures have been taken according
to the Manual.
3. Before starting the machine, confirm
the motor is turning in the direction as
labeled on the machine.
OPERATION – Filter Cleaning
1. Attached compressed air to the unit for
cleaning purposes, at a source
pressure of 90 PSI. The connection
point is accessed by removing the
panel on the side of the unit where the
PSI label is in place and requires a 1/4”
NPT fitting. A regulator must be
incorporated in line to set pressure. Do
not exceed 90 PSI pressure.
2. Refer to control panel for initiating
power to the motor and subsequent
vacuum from the unit.
3. The vacuum hood should be placed an
approximate distance of 12” from the
smoke source for efficient operation.
4. The pulse cleaning button is used for
filter cleaning and for maximum
effectiveness should be used as
follows:
• The unit should be powered off and
the button pushed one to two times
before and after every use.
• Cleaning as noted above should be
daily, and as any decrease in
vacuum is observed. If pressure